![]() I would be very grateful for any help and insights into what's going on here. Or shouldn't I have imported the master public key through the EPS config.ini file (and rather imported it through the Bitcoin Core console)? Is the issue that Bitcoin Core has derived an address from my master public key that Electrum hasn't generated yet? But I'd think that Electrum should recognise all addresses that belong to the wallet (and ismine returned false and I can't sign messages with the address in my Electrum wallet as it says the address doesn't belong to the wallet). How is this possible? The Bitcoin Core wallet has private keys disabled + blank wallet and is named "electrumpersonalserver", so it should be dedicated to EPS and since I only imported and master public key, shouldn't it contain only addresses derived from that one master public key? Bitcoin Core is showing many other addresses that are not present in Electrum, besides this one that I sent a test transaction to. Since your wallet is of the former type, Electrum will refuse to generate any new keys for your wallet. You cannot store both types of keys in a single Electrum 2.x wallet. Same problem: my wallet now shows a different amount in Bitcoin Core (including the abovementioned address) than in Electrum (excluding that address). With Electrum 2.x, a wallet can contain either keys you've imported from elsewhere, or keys which are generated (deterministically) by Electrum. I double checked that only one MPK is mentioned in EPS's config.ini file, and I also created a new wallet in Bitcoin Core and resynced the EPS. ![]() I also can't sign messages with the address in Electrum with my hardware wallet connected as Electrum says the address doesn't belong to the wallet. The ismine("address") command in Electrum returns false. This transaction now shows in Bitcoin Core as belonging to one of my watch-only addresses but does not show in Electrum. Create launcher through the Terminal application which is used to insert low level commands Run it by pressing command key () and spacebar at the same time. I tried to send a test amount to one of the addresses in Bitcoin Core that were not shown in Electrum. However, Bitcoin Core's "receiving addresses" show addresses that do not belong to my wallet according to Electrum. Everything works: I get the green circle in Electrum, saying I'm connected to (only) my own node, and I can watch my wallet in Bitcoin Core. I generated a watch-only wallet in Bitcoin Core of my hardware wallet by providing the master public key in the config.ini file (no other master public keys, only the one of my hardware wallet as shown on Electrum). Once you have clicked ' Send ', it may take a while to receive into your Electrum wallet. If you’re sending it from an exchange, paste the public key into the send address field under the withdrawal options on the exchange. I installed Electrum Personal Server (EPS) and connected my hardware wallet with Electrum via Tor. Paste the public key to where you are sending the Bitcoin. I got a full node (pruned) up and running with Bitcoin Core via Tor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |